A new way to clean aviation torque tubes and stator rings efficiently with maximum effectivity
In association with a major Airplane Brake Manufacturer our Aerota system has been designed and built specifically for cleaning Airplane brake components to accommodate brake types from ALL major Airplanes and this unique system meets the needs of overhaul / service workshops worldwide.
The time and cost savings realized from using the Aerota cleaning system are phenominal
- it will double your thru-put / ttttttuuuurnaround time on brake overhaul
SHOWN BELOW A SCHEMATIC OF OUR AEROTA SYSTEM
The Aerota can be loaded with an optional elevator to reduce risk of personal injury or operator back strain.
The unit is designed to take a full brake system set from all major airplanes types currently operating today - including
most 'heavy airplane types' including Boeing 747, DC-10 etc.
Once the Aerota system is loaded the fully automated cleaning process can begin, typically 10-15 minutes, allowing the operator
to carry out alternate tasks. During the cleaning process the specially designed drum rotates at slow speed allowing
the cleaning agent to penetrate all component surfaces to give a overall even clean finish on the brake set.
SHOWN BELOW - BEFORE & AFTER TREATMENT SHOTS
before after 10-15 minutes
The Aerota system has its own in-built dust extractor which leaves the components and the working
environment dust free thereby reduces any Health / Safety risks. When the Clean Cycle is complete the system
will de-activate and the cleaned brake parts can be removed.
As with all cleaning procedures, cleaned components should be subjected to an M.P.I. or
dye penetrant test to ensure total serviceability.
Once complete the next batch of brake parts can be immediately loaded.
SHOWN BELOW AIRPLANE APPLICABILITY CHART
Aerota Cleaning System Fabrication Detail
The Aerota Cleaning System is constructed of reinforced hi-grade steel and is also rubber lined
to allow reduced reduced noise and cabinet wear.
The cabinet base has a steel-lined trough in manganese and this houses twin chrome steel paddles to
propel the cleaning material. The impeller bearings are protected by triple sealed bearings designed for years
of active service with minimal maintenance.
SHOWN BELOW IS A CLOSE UP VIEW OF THE AEROTA SYSTEM
System Dimensions 81" wide x 45.3" high x 39.4" deep, Total Weight approx = 1550 lbs
The Aerota system is free standing and can be practically moved if equipment needs to be re-arranged
in a maintenance bay or workshop area. This system is also compatible with all
worldwide power sources, incl the USA, and carries full C.E. Certification.
The AEROTA system is efficient, effective and gives a high standard
of uniformity to cleaned conponents. It is a valuable piece of equipment to your airplane
brake overhaul workshop.
ROTOWASH products SALES CONTACT DETAILS aerota home page
Last updated September 2007 by